How to confirm failed O2 sensor?
#1
Instructor
Thread Starter
Join Date: Dec 2004
Location: Netherlands
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
How to confirm failed O2 sensor?
Hello,
My car has occasional rough (high) idle, and overall response is not what I expect it to be. I suspect a failed O2 sensor. Is there a cheap way to confirm this is the culprit? Perhaps by unplugging the O2 sensor and take it for a drive? Would it be harmful for the engine?
Thanks,
Patrick
My car has occasional rough (high) idle, and overall response is not what I expect it to be. I suspect a failed O2 sensor. Is there a cheap way to confirm this is the culprit? Perhaps by unplugging the O2 sensor and take it for a drive? Would it be harmful for the engine?
Thanks,
Patrick
#2
Rennlist Member
It's a bit of a reach and helps if you remove the blower duct (to get second hand in there) but the connector is mounted with a clip up against the forward left corner of the engine bay compartment (driver's side in LHD cars). It's a simple connector with a rubber boot but it really requires two hands to disconnect and reconnect. Be very careful as the plastic clip that secures the connector wiring is prone to breaking ($2.49 part).
I've found that getting rid of those silly crimp clamps on the ISV valve and replacing them with real hose clamps helped with my idle...I think I was getting some air leakage past the crimp clamps and made my idle hunt. I had to sister two narrow band clamps with each other because I couldn't find a narrow band clamp that had enough circumference that would fit in the groove on the rubber hoses into which the ISV valve goes. This will make sense if you look at the assembly. Good luck!
When was the last time you had a valve job?
I've found that getting rid of those silly crimp clamps on the ISV valve and replacing them with real hose clamps helped with my idle...I think I was getting some air leakage past the crimp clamps and made my idle hunt. I had to sister two narrow band clamps with each other because I couldn't find a narrow band clamp that had enough circumference that would fit in the groove on the rubber hoses into which the ISV valve goes. This will make sense if you look at the assembly. Good luck!
When was the last time you had a valve job?
#3
If you can get your hands on a diagnostic tool (ie, Bosch Hammer), you can check codes.
The sensor is not very expensive (in Porsche dollars), it is easy to replace, and failure is very common--I thought I read that they last around 40K miles on average. Based on this, I would change it.
My idle was hunting and I cleaned the ISV. Did nothing. Replaced the O2 sensor and fixed the problem.
There is a great write-up in the DIY section in refrence to replacing the sensor.
Jim
The sensor is not very expensive (in Porsche dollars), it is easy to replace, and failure is very common--I thought I read that they last around 40K miles on average. Based on this, I would change it.
My idle was hunting and I cleaned the ISV. Did nothing. Replaced the O2 sensor and fixed the problem.
There is a great write-up in the DIY section in refrence to replacing the sensor.
Jim
#5
Racer
Join Date: Oct 2010
Location: Annapolis Maryland
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
Replaced my O2 sensor this weekend. Got a good deal i guess. They used to run 120 bucks or more for the direct replacement, but I got mine for 92 bucks. Anyway, of course the sucker was rust welded on. Def have a noticable improvement in the running of the engine. Smoother.
#7
Hello,
My car has occasional rough (high) idle, and overall response is not what I expect it to be. I suspect a failed O2 sensor. Is there a cheap way to confirm this is the culprit? Perhaps by unplugging the O2 sensor and take it for a drive? Would it be harmful for the engine?
Thanks,
Patrick
My car has occasional rough (high) idle, and overall response is not what I expect it to be. I suspect a failed O2 sensor. Is there a cheap way to confirm this is the culprit? Perhaps by unplugging the O2 sensor and take it for a drive? Would it be harmful for the engine?
Thanks,
Patrick
It really wont hurt the engine, but it could damage the cat over extended periods of time.
There are certianly other things that could cause your symptoms.