Notices
928 Forum 1978-1995
Sponsored by:
Sponsored by: 928 Specialists

Is this worth saving??

Thread Tools
 
Search this Thread
 
Old 05-14-2023, 12:51 PM
  #46  
brickwhite
5th Gear
 
brickwhite's Avatar
 
Join Date: May 2023
Location: Denver
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Default

Wow...
Old 05-24-2023, 12:42 PM
  #47  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Bad news yesterday, I’ve had an injector wire harness on order since Feb. got an email stating it was discontinued. Ughh. I did a very good job repairing the old one but I was hoping for brand new wires.
I got the harness spliced and new TPS and air temp pig tails added. It’s nice having access to an avionics repair shop.
I’m almost certain this car was parked with a fuel delivery problem back in 05. I found copies of the CE panel diagram with fuel pump relay highlighted inside the car.
I ran all the continuity checks on the repaired harness and hooked it up. Turned over the engine and presto, fuel flowed nicely. Just got the injectors back from the shop so now the intake goes back together and fingers crossed I should be able fire it up today or tomorrow.



The following users liked this post:
JBT3 (05-24-2023)
Old 05-26-2023, 02:16 AM
  #48  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Got it all back together and it runs so
smooth. Fired right up!! Almost 20 years dormant and it’s back alive. Shifts smooth as well. Definitely sounds different than my 83 US.



The following 5 users liked this post by Turbinesurgeon:
Darklands (05-26-2023), monkez (05-26-2023), Mrmerlin (05-26-2023), RennHarry (05-26-2023), slownrusty (05-26-2023)
Old 05-26-2023, 04:09 AM
  #49  
928cs
Race Car
 
928cs's Avatar
 
Join Date: Aug 2003
Location: Le Mans, France
Posts: 3,573
Received 513 Likes on 324 Posts
Default

Congratulations. Euro S are great cars
Old 05-26-2023, 09:36 AM
  #50  
RennHarry
Racer
 
RennHarry's Avatar
 
Join Date: Mar 2021
Posts: 432
Received 202 Likes on 142 Posts
Default

Nicely done!
Cheers
Old 05-26-2023, 09:59 AM
  #51  
linderpat
Rennlist Member
 
linderpat's Avatar
 
Join Date: Nov 2006
Location: Pittsburgh, PA
Posts: 14,401
Received 2,257 Likes on 1,258 Posts
Default

Holy crap - wow! Great job. Super save.
Old 05-26-2023, 11:41 AM
  #52  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Thanks guys!
Old 05-28-2023, 10:24 AM
  #53  
Chuck Schreiber
Addict
Rennlist Member

 
Chuck Schreiber's Avatar
 
Join Date: Aug 2002
Location: Plano, Tx.
Posts: 3,453
Received 124 Likes on 81 Posts
Default

Great job!!!
And just think, it was on it’s way to death Row!!
Old 05-28-2023, 01:25 PM
  #54  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Originally Posted by Chuck Schreiber
Great job!!!
And just think, it was on its way to death Row!!
Haha, love the pun
Old 05-30-2023, 05:13 AM
  #55  
Mrmerlin
Team Owner
 
Mrmerlin's Avatar
 
Join Date: May 2004
Location: Philly PA
Posts: 27,930
Received 2,278 Likes on 1,263 Posts
Default

Nice save I hope you will enjoy driving this machine
Old 11-06-2023, 08:38 PM
  #56  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Well it’s been awhile since I’ve posted and would like to share some progress. I’ve pretty much done everything in the engine area except timing belt and new drive belts. Over the summer I rebuilt the steering rack, changed motor mounts, and new silicone oil pan gasket. Installed new injectors and did an intake refresh. Went through the entire CE panel and discovered a few bad relays. Everything electrical is working and in good condition. Now it’s time to focus on the body. I picked up a used Euro fender when I was out in PA. I need to find a good body shop that can paint a 928 very well.
After sitting for over 20 years I pulled her out of the garage today under her own power!!




The following 5 users liked this post by Turbinesurgeon:
84dizzy (11-06-2023), 928cs (11-07-2023), JBT3 (11-08-2023), RennHarry (11-06-2023), WestInc (11-07-2023)
Old 11-07-2023, 11:44 AM
  #57  
soontobered84
Rennlist Member
 
soontobered84's Avatar
 
Join Date: Mar 2002
Location: Texas
Posts: 5,946
Received 268 Likes on 188 Posts
Default

Originally Posted by Turbinesurgeon
After sitting for over 20 years I pulled her out of the garage today under her own power!!
So let's go back to the original question you asked at the start of the thread; "Do YOU think it was worth saving?"

My vote is definitely yes. Great job!!

Old 11-07-2023, 12:24 PM
  #58  
RennHarry
Racer
 
RennHarry's Avatar
 
Join Date: Mar 2021
Posts: 432
Received 202 Likes on 142 Posts
Default

Holy smokes. "They were going to crush it"... NICE save (I know you are still in process)

Did you solve the title issue?
Cheers
Old 11-07-2023, 11:16 PM
  #59  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Originally Posted by soontobered84
So let's go back to the original question you asked at the start of the thread; "Do YOU think it was worth saving?"

My vote is definitely yes. Great job!!

Absolutely worth it. It was so difficult to originally asses this car. It looked pretty ratty. Everything is pretty solid and it runs very well. Of course I had to sort through everything but that’s the best enjoyment for me.
The following 2 users liked this post by Turbinesurgeon:
soontobered84 (11-08-2023), WestInc (11-09-2023)
Old 11-07-2023, 11:20 PM
  #60  
Turbinesurgeon
Instructor
Thread Starter
 
Turbinesurgeon's Avatar
 
Join Date: Jun 2021
Location: AZ
Posts: 164
Received 121 Likes on 51 Posts
Default

Originally Posted by RennHarry
Holy smokes. "They were going to crush it"... NICE save (I know you are still in process)

Did you solve the title issue?
Cheers
Thanks!!

Title was pretty easy. AZ has an abandon vehicle process to get a clean title. I paid the land owner’s wife extra money to sign the paperwork and sign over the title to me when they mail it. Took a few months but was a must for me if I was going to invest time and money.
The following users liked this post:
RennHarry (11-08-2023)


Quick Reply: Is this worth saving??



All times are GMT -3. The time now is 01:11 PM.