Does anyone have pictures of the wiring in the pod switch connectors?
#1
Rennlist Member
Thread Starter
Does anyone have pictures of the wiring in the pod switch connectors?
I pulled stitch's pod last year after the tree incident, and when I started to work on reassembly, I found a couple of wires loose wires. Does anyone have good, close pictures of these connectors so I can figure out where to reconnect them?
This is the driving lights connector.
This is for that mystery switch at the bottom left. (I seriously don't know what that switch is supposed to do.)
This is the driving lights connector.
This is for that mystery switch at the bottom left. (I seriously don't know what that switch is supposed to do.)
#2
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Shawn, here is what I have. I don't know if it will help. The bottom left switch is the one to reset the trip mileage in the speedo.
__________________
ReDesign by FEATHER
by Jerry Feather
Producer for 928 of:
-Hatch Latch Receiver Liner--All Versions
-Replacement Heavy Duty Spare Tire Cover
-Flush Center Console Conversion
-Cowl Cover, Cowl Seal, & Shell Stickers--All versions
(RHD included)
-Aluminum Gas Cap Ratcheting Pawl
ReDesign by FEATHER
by Jerry Feather
Producer for 928 of:
-Hatch Latch Receiver Liner--All Versions
-Replacement Heavy Duty Spare Tire Cover
-Flush Center Console Conversion
-Cowl Cover, Cowl Seal, & Shell Stickers--All versions
(RHD included)
-Aluminum Gas Cap Ratcheting Pawl
The following users liked this post:
Shawn Stanford (08-31-2023)
#3
Rennlist Member
Thread Starter
Woops. Disregard.
Last edited by Shawn Stanford; 08-31-2023 at 09:49 PM.