Door Lock motor pin out for test
#1
RL Community Team
Rennlist Member
Rennlist Member
Thread Starter
Door Lock motor pin out for test
Can anyone tell me the pinouts for this door Lock motor so I can test it. Sold one of my 3 to another member and want to make sure it works before shipping (or at least which is the ground pin so I don't fry it).
#2
Rennlist Member
From the '90 wiring diagram, sheet 3, it looks like Pin 2 is your ground:
ETA: I looked at the '86 diagram (Page 6), as well, and pin 2 on the door locks are also the grounds.
Cheers
ETA: I looked at the '86 diagram (Page 6), as well, and pin 2 on the door locks are also the grounds.
Cheers
Last edited by Zirconocene; 10-12-2023 at 04:39 PM.
#3
RL Community Team
Rennlist Member
Rennlist Member
Thread Starter
The pin I've marked in my photo as #2 or #2 in the above wiring diagram as I don't know how to correlate the diagram to my photo.
#4
Rennlist Member
Those diagrams are for the door lock/key cylinder, not the motor. A 4 pin motor is pre 89. The wiring diagram for an 88 shows pin 3 to be ground. It would be easier with the connector for wire assignment.
This is the correct pin order. 3 is ground 4 is power 1@2 to control unit
This is the correct pin order. 3 is ground 4 is power 1@2 to control unit
Last edited by ZEUS+; 10-13-2023 at 12:35 AM. Reason: Diagram
#5
RL Community Team
Rennlist Member
Rennlist Member
Thread Starter
Those diagrams are for the door lock/key cylinder, not the motor. A 4 pin motor is pre 89. The wiring diagram for an 88 shows pin 3 to be ground. It would be easier with the connector for wire assignment.
This is the correct pin order. 3 is ground 4 is power 1@2 to control unit
This is the correct pin order. 3 is ground 4 is power 1@2 to control unit