Giving up on my project :(
#18
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Originally Posted by Rich Sandor
I bet the poor guy has about 50 PM's just for the 968 bits.
#22
Racer
Thread Starter
Join Date: Aug 2002
Location: San Diego, CA
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
Sorry for slow responses... I wasn't home most of the weekend. Lots of PMs...
To clarify the JB weld thing... the balance shaft oiling holes were welded shut... I just put a little epoxy (i.e. JB weld) over the real welds to make absoluetly sure that they would not leak under any circumstance.... that's all.
I have received some PMs to take the whole project... and a lot of PMs for parts. Either way, please make some sort of offer for what you're looking for. I imagine it will take some time to determine where everything is going, so please be paitient. Keep in mind that I'm more willing to sell the project as a whole to a "good home", as pet lovers would say... but I'm entertaining everything for now.
To clarify the JB weld thing... the balance shaft oiling holes were welded shut... I just put a little epoxy (i.e. JB weld) over the real welds to make absoluetly sure that they would not leak under any circumstance.... that's all.
I have received some PMs to take the whole project... and a lot of PMs for parts. Either way, please make some sort of offer for what you're looking for. I imagine it will take some time to determine where everything is going, so please be paitient. Keep in mind that I'm more willing to sell the project as a whole to a "good home", as pet lovers would say... but I'm entertaining everything for now.
#24
Racer
Thread Starter
Join Date: Aug 2002
Location: San Diego, CA
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
A price breakdown for everything I have (including a total for the whole project) is now available at http://www.topherdub.com/951ComponentPrices.xls
There has been a lot of interest in a few of the items and some interest in taking the whole project on, so here's what I'll do...
I'll take offers on the whole project until July 31. If an acceptable offer comes from someone that intends to finish the project then off it goes to a new home (I would much rather see someone take the project and finish it... dyno sheets and a ride for me at some point are to be expected
After that, send it bids for the bits and pieces until Aug. 10th - highest bidders get their parts.
I really want to see this car done and putting 550 HP to the ground...and I want a ride!
There has been a lot of interest in a few of the items and some interest in taking the whole project on, so here's what I'll do...
I'll take offers on the whole project until July 31. If an acceptable offer comes from someone that intends to finish the project then off it goes to a new home (I would much rather see someone take the project and finish it... dyno sheets and a ride for me at some point are to be expected
After that, send it bids for the bits and pieces until Aug. 10th - highest bidders get their parts.
I really want to see this car done and putting 550 HP to the ground...and I want a ride!
#25
Rennlist Member
Good luck. Such a pity you can't finish. I hope that someone can and you can see it.
#28
Racer
Thread Starter
Join Date: Aug 2002
Location: San Diego, CA
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts