FS Lindsey Racing Ultra Mounts and Factory Turbo Headers
#1
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: May 2001
Location: Melbourne, Florida
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
FS Lindsey Racing Ultra Mounts and Factory Turbo Headers
I have for sale a pair of Lindsey Racing Ultra Mounts. These are the adjustable height mounts. I was running them 5mm shorter than the factory mounts but I also have the extra shim to run them at factory height as well. These have ~7k miles on them and I am asking ~$175 shipped to the lower 48 for them. The mounts are SOLD!!!! Thanks!!!
Here is a link to the mounts on Lindsey's site: Ultra Mounts
I also have a set of the updated headers from my car. These are the late style with bellows and they have ~90k miles on them. They are in good shape and don't have any leaks. Also included are allen style studs with copper nuts for monting the headers to the cylinder head. Asking $150 plus shipping for them.
Thanks,
Rob
Here is a link to the mounts on Lindsey's site: Ultra Mounts
I also have a set of the updated headers from my car. These are the late style with bellows and they have ~90k miles on them. They are in good shape and don't have any leaks. Also included are allen style studs with copper nuts for monting the headers to the cylinder head. Asking $150 plus shipping for them.
Thanks,
Rob
Last edited by Rob; 11-06-2011 at 11:06 AM.
#3
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: May 2001
Location: Melbourne, Florida
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
Hi Adonay, I am selling the mounts and headers because I parted out my car. I'm willing to ship to Europe if you cover the shipping cost.
Thanks,
Rob
Thanks,
Rob
#7
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: May 2001
Location: Melbourne, Florida
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
The mounts are sold! Thanks!!! It hard for me to say how they compare to good factory mounts because when I replaced mine they were bad. I would say they are probably not as smooth as the factory fluid filled mounts but not bad at all. I ran them in my street 2.7liter with balance shaft delete.
Trending Topics
#9
#10
Addict
Rennlist Member
Rennlist Member
Thread Starter
Join Date: May 2001
Location: Melbourne, Florida
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
Mine did at first too, but I changed the setup slightly on them and it made a big difference. What I did was not tighten the assemblies down very tight like the instructions said too but instead tightened them up very lightly to eliminate the play and used lock tight to keep them from coming loose. IIRC this made a big difference in the amount of vibration transmitted by removing all the preload in the isolators thus allowing them to dampen out a lot of the vibrations. I didn't think mine felt a lot worse than the factory mounts, but defiantly still not a smooth.