Rear Axle Cooling Duct Upgrade?
#46
Rennlist Member
My parts came this week from Suncoast Parts and it was a nice Sunday afternoon project. The Renntorq made it easy to remove the wheels and as others had said it took longer to jack up the car than to install. Cheap upgrade and should help at Watkins Glen HPDE next month.
John
John
The following 3 users liked this post by JohnC4S:
#47
Addict
Rennlist Member
Rennlist Member
My parts came this week from Suncoast Parts and it was a nice Sunday afternoon project. The Renntorq made it easy to remove the wheels and as others had said it took longer to jack up the car than to install. Cheap upgrade and should help at Watkins Glen HPDE next month.
John
John
The following 2 users liked this post by f1soul:
Diablo Dude (04-21-2024),
GrantG (04-21-2024)
#50
Rennlist Member
I am sure it can be done without removing the wheels but due to my major abdominal surgery last August and my flexibility issue because of it, removing the wheels made the install much easier for me. My "Seppuku" site does not agree with some of my activities even after 7 months
John
John
Last edited by JohnC4S; 04-22-2024 at 12:52 AM.
The following users liked this post:
GrantG (04-22-2024)
#51
Race Car
They sent me 2 RIGHT SIDE air guides.
Ugh. But their customer service is really good and as soon as I notified Suncoast via email they replied right away and shipped out a LEFT SIDE.
Ugh. But their customer service is really good and as soon as I notified Suncoast via email they replied right away and shipped out a LEFT SIDE.
#52
Rennlist Member
Just did mine last night. Took about 20 minutes start to finish. Backed the car up on Race Ramps. Plenty of room !
Last edited by GT3 Mike; 04-24-2024 at 02:00 PM.
The following 5 users liked this post by GT3 Mike:
Diablo Dude (04-24-2024),
EMdoc (04-24-2024),
GrantG (04-24-2024),
Jbravo23 (04-25-2024),
RolandT (04-25-2024)
#55
Rennlist Member
They are actually Rhino Ramps. They are high enough to do full exhaust on the GT3. Everything just clears.
The following 3 users liked this post by GT3 Mike:
#56
Looks like Home Depot sells them too, and for $10 less
#57
Rennlist Member
I never drove it up the front. Next time I get a chance I will try it. You will definitely need FAL though.
#58
Addict
Rennlist Member
Rennlist Member
Finally installed my cooling ducts today (after axle boot replacement at dealer). Pretty straightforward - just need T25 and T30 bits.
The following 3 users liked this post by GrantG:
#60
Addict
Rennlist Member
Rennlist Member