DIY - Wiring overhead console for Radar etc.
#166
Rennlist Member
Just finished this install on my 2024 Targa 4S! Thanks to all that contributed information. Was very easy to do with the help of this thread. Only thing I didn’t do was run wire under #2 housing. Just exited wire between #1and #2 at the seam, and then used zip tie to keep concealed and out of the way! Overall a really clean and easy job!
The following users liked this post:
audi4t (11-04-2023)
#168
Just finished this install on my 2024 Targa 4S! Thanks to all that contributed information. Was very easy to do with the help of this thread. Only thing I didn’t do was run wire under #2 housing. Just exited wire between #1and #2 at the seam, and then used zip tie to keep concealed and out of the way! Overall a really clean and easy job!
#169
Rennlist Member
Re-read this post: https://rennlist.com/forums/992/1185...l#post18937957
Last edited by Scott P; 11-05-2023 at 09:47 AM.
The following users liked this post:
txpackers (11-06-2023)
#171
#172
Does adding "Preparation for Porsche Dashcam" change anything or make things easier for installing a radar detector with Blendmount?
#173
Rennlist Member
#174
I admit I originally just did a search for “preparation” and came up with nothing. Now that I went back, I only found a couple posts from a couple years ago, merely speculating about the new option.
I’m wondering if anyone with the option has seen or noticed any change in the process outlined here.
I’m wondering if anyone with the option has seen or noticed any change in the process outlined here.
#175
Burning Brakes
Search - Preparation for Porsche Dashcam
I have a complete write up of how to use the OEM connector that comes with the factory installed prewiring and the connector u need to purchase to make the connection.
Just a suggestion be a little less specific when running your search terms to get more results
I have a complete write up of how to use the OEM connector that comes with the factory installed prewiring and the connector u need to purchase to make the connection.
Just a suggestion be a little less specific when running your search terms to get more results
#176
Did the install for the prewire. Mostly easy but not much room to stuff the wires. Me being ****, I bent the metal clip on the dome, the one you slide the credit card to unhook. Is that an orderable part? I bent it back and it works fine but it annoys me that it's a little crooked.
#178
Rennlist Member