RS Club Sport Straße - Rivi
#1
Three Wheelin'
Thread Starter
RS Club Sport Straße - Rivi
My friend showed up to the 356 Dana Point Concours with this Club Sport Straße of from Sweden on a 1 year temp DOT permit.
I figured bad pics are better than no pics....
I figured bad pics are better than no pics....
#4
Nordschleife Master
#6
Nordschleife Master
So .. a Clubsport 'Street' was an RS with a welded in roll-cage. Do I have that right? So .. this is an RS ordered with or modified with a Clubsport wing kit and then the owner had an aftermarket roll cage installed .. Is that bad?
#7
Banned
Join Date: Jun 2008
Location: Potsdam, Germany
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
There are only RS Versions M002 and Clubsport M003 versions and some Special Version M007 for Japan with rear seats and power windows
Trending Topics
#8
Nordschleife Master
You know a lot, so one more question please. Did Porsche make RHD RS for Japan?
#9
Banned
Join Date: Jun 2008
Location: Potsdam, Germany
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
I know they made RHD version even a Clubsport M003. I would think since that they made a Version M007 for Japan with rear seats, power windows and with airbags standard that they had a RHD version.
But I know you could order it in the UK in LHD and would think you could do that also in Japan.
Richard
But I know you could order it in the UK in LHD and would think you could do that also in Japan.
Richard
#10
Why do I feel so left out!
Rennlist Member
Rennlist Member
JP - Yes - also made them for down here....
Simon.
Simon.
#13
Why do I feel so left out!
Rennlist Member
Rennlist Member
Its one of my buddys' cars from his collection.
He recently flew (!) one of his cars over for Rennsport reunion... I will try and find a few more
He recently flew (!) one of his cars over for Rennsport reunion... I will try and find a few more
#14
Nordschleife Master
#15
Not quite
the RS could be had w/ a bolt in Matter cage for the rear seat area
the RS/CS came w/ a welded in full cage as used in the Cup cars, I've seen 2 versions of these one version has the bars in an X across the doors the other has a descending diagonal as used on 964Cups. Both have a transverse bar at the knees
the seats were also different, the RS used the same seats as the Speedster, the RS/CS had FIA certified racing seats and 6 pt harness std.
RS/CS has a sun visor only on the drivers side and carpeting was optional
RS/CS doesn't have front kick panel carpet and does have the manual battery disconnect next to where the drivers side air vent would have been
RS/CS has the strut brace standard, RS it's optional
the RS could be had w/ a bolt in Matter cage for the rear seat area
the RS/CS came w/ a welded in full cage as used in the Cup cars, I've seen 2 versions of these one version has the bars in an X across the doors the other has a descending diagonal as used on 964Cups. Both have a transverse bar at the knees
the seats were also different, the RS used the same seats as the Speedster, the RS/CS had FIA certified racing seats and 6 pt harness std.
RS/CS has a sun visor only on the drivers side and carpeting was optional
RS/CS doesn't have front kick panel carpet and does have the manual battery disconnect next to where the drivers side air vent would have been
RS/CS has the strut brace standard, RS it's optional