Engine Removal Question: Bumper on or off?
#1
Rennlist Member
Thread Starter
Engine Removal Question: Bumper on or off?
I am going to drop the engine/ trans in a few months and am reading about it now.
Question: For those who have done it, did you remove bumper or not?
I am curious. I am using my scissor lift and am excited about it.
Thanks,
--Michael
Question: For those who have done it, did you remove bumper or not?
I am curious. I am using my scissor lift and am excited about it.
Thanks,
--Michael
#2
Three Wheelin'
The first time I did it,I removed my rear bumper. I was using floor jacks and jack stands,and I could not get the car high enough to clear the bumper. The second and third time,I left the bumper on, as I was using my friends lift. I assume the scissor lift will get it high enough to clear the bumper. Have fun.
Emerald
Emerald
#3
Race Car
ON. I've used the MaxJax lift and it's gets it high enough that the ISV goes out through one of the exhaust cutouts, using a harboe freight lift table to lower the engine.
#4
Hmmm... I used to clean up the underside first, then lower the car to the floor, ( rears wheels off ), then finish up on top, raise the car leaving the engine on the pallet on the floor.
Of course that was my '75 2.7S.... So, a few years ago.
Jim
Of course that was my '75 2.7S.... So, a few years ago.
Jim