Car won't start after UAOS install...
Popular Reply
12-27-2023, 08:59 PM
Rennlist Member
Thread Starter
Fixed it, it was what @Porschetech3 said. One of the rubber boots that connects the throttle body plenum to the passenger intake manifold wasn't on correctly.
Runs fine now!
Runs fine now!
#4
Rennlist Member
It's definitely got a "big" vacuum leak....check the rubber boots on the center intake plenums, they always give people problems, also like Brad mentioned, check the power brake booster hose and the adapter to the intake, thee is an o'ring at the intake that can fall out while its disassembled..
The following 2 users liked this post by Porschetech3:
996-CAB (12-27-2023),
islaTurbine (12-28-2023)
#5
Racer
Mine was doing this and I got a TB fault code. Unplugged and repligged the TB connector and it fired up.
#6
Rennlist Member
Thread Starter
Fixed it, it was what @Porschetech3 said. One of the rubber boots that connects the throttle body plenum to the passenger intake manifold wasn't on correctly.
Runs fine now!
Runs fine now!