How to Jack up your Porsche with a 4 post lift.
#1
Advanced
Thread Starter
How to Jack up your Porsche with a 4 post lift.
I recently performed a bunch of work on my car and wanted to Jack her up and didn’t want to spend $1k for the Jack system for my lift. Enter this beauty. It is military grade and made in the USA. I did have to Hack
off the nub on the mounting point for clearance but found this to be an excellent solution.
off the nub on the mounting point for clearance but found this to be an excellent solution.
Last edited by Firedome48; 03-25-2022 at 08:19 AM.
The following users liked this post:
Mike Billings (03-25-2022)
The following users liked this post:
Firedome48 (03-26-2022)
#4
Advanced
Thread Starter
I used a hacksaw and cut the nub off the Jack head. I did this because of the clearance issue to get under the 911. I think you only have about 5 1/2 inches of clearance. So yes it now is able to Jack anything up.
it is machined on so I am
it sure if it is replaceable.
it is machined on so I am
it sure if it is replaceable.
Last edited by Firedome48; 03-26-2022 at 02:00 PM.
#5
I used a hacksaw and cut the nub off the Jack head. I did this because of the clearance issue to get under the 911. I think you only have about 5 1/2 inches of clearance. So yes it now is able to Jack anything up.
it is machined on so I am
it sure if it is replaceable.
it is machined on so I am
it sure if it is replaceable.
Vic