Fab Speed Tune? - New Headers + CEL
#31
Rennlist Member
I’m running Fabspeed headers, 200 cell cats, stock side mufflers with center delete x pipe. Never had a CEL with any these tune: stock, 91,93, and 100 octane Cobb tunes.
The following users liked this post:
RABjr (03-31-2022)
#32
Nordschleife Master
Same here... no CEL with 200 cell cats, x-pipe with single o2 sensor, and RSR mufflers.
The following users liked this post:
RABjr (04-05-2022)
#33
Racer
#34
Instructor
Thread Starter
#35
Instructor
Thread Starter
Good news on Softronic Tune. I order the tune, received the programmer and uploaded new tune. Car runs better, and CEL is gone!
The following 3 users liked this post by RABjr:
#36
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
I was going to chime in a recommend that myself. Scott is a Porsche master tech and has been tuning them for over 30 years, he is very very good and I'm sure can take care of that for you.
__________________
SOUL PERFORMANCE PRODUCTS
Quality Exhaust Solutions, Fair Pricing, and Outstanding Service
John Gaydos- Owner, Performance Specialist
Cell - (484) 883-6197
johng@soulpp.com
Jon Wheel - Marketing Manager
jwheel@soulpp.com
SOUL PERFORMANCE PRODUCTS
Quality Exhaust Solutions, Fair Pricing, and Outstanding Service
John Gaydos- Owner, Performance Specialist
Cell - (484) 883-6197
johng@soulpp.com
Jon Wheel - Marketing Manager
jwheel@soulpp.com
#37
Rennlist Member
The following users liked this post:
FlatSix911 (04-06-2022)
#38
#39
Rennlist Member
IMPORTANT!!!
For those on this thread that have headers. Be sure to check your header bolts. I’m missing 2 of mine. Apparently these are notorious for backing out. According to my mechanic, he has seen it even on stock manifolds an X51 headers. If enough of them are loose or missing the remaining bolts can sheer off, leaving them stuck into the head and it is a real PITA to Extract and/or repair.
the bolt heads use an E12 socket. Otherwise known as an inverted torx.
For those on this thread that have headers. Be sure to check your header bolts. I’m missing 2 of mine. Apparently these are notorious for backing out. According to my mechanic, he has seen it even on stock manifolds an X51 headers. If enough of them are loose or missing the remaining bolts can sheer off, leaving them stuck into the head and it is a real PITA to Extract and/or repair.
the bolt heads use an E12 socket. Otherwise known as an inverted torx.
Last edited by swoardrider; 04-08-2022 at 12:50 PM.
The following users liked this post:
JAAM (04-08-2022)
#40
Racer
TopSpeed 200 cell headers are out of stock.
Anyone have input on
Anyone have input on