Aftermarket Ceramic Rotors (PCCB Replacement)
#1
Drifting
Thread Starter
Aftermarket Ceramic Rotors (PCCB Replacement)
Will someone kindly post the .2 PCCB rotor measurements? As printed on the rotor itself? Tryig to source a solution and i can't get to my car just now. TIA. Will post my findings.
Only 2010/2011 GT3/RS rotor measurements please!
Cheers-
Only 2010/2011 GT3/RS rotor measurements please!
Cheers-
#6
Drifting
Thread Starter
Will do!
Trending Topics
#9
If StopTech comes out with a Ceramic alternative to PCCB, it will be flawless !
I've had the pleasure of working with the guys at StopTech for five years at the track and they were a large part of my Championships.
They (S.R. in particular) are fanatics about R&D and attention to detail.
I've had the pleasure of working with the guys at StopTech for five years at the track and they were a large part of my Championships.
They (S.R. in particular) are fanatics about R&D and attention to detail.
#11
Rennlist Member
I think I heard it on an Adam corolla car cast podcast with christini from ST as the guest...
it did not sound imminent at the time I heard it..
brembo type III - and done... not ceramic but amazing - just put them on my .1 RS as pccb replacements (380 front 350 rear)
it did not sound imminent at the time I heard it..
brembo type III - and done... not ceramic but amazing - just put them on my .1 RS as pccb replacements (380 front 350 rear)
#14
Drifting
Thread Starter
Stoptech is not yet close to a ceramic solution.
I have been in contact with MovIt who has developed a very interesting ceramic rotor which sounds in their literature to be technologically superior to OE PCCB in every way. Also pre-bedded pads(!).
As soon as I receive full information (hopefully by tomorrow AM) I will update this thread.
I have been in contact with MovIt who has developed a very interesting ceramic rotor which sounds in their literature to be technologically superior to OE PCCB in every way. Also pre-bedded pads(!).
As soon as I receive full information (hopefully by tomorrow AM) I will update this thread.