“Liesl II” Build Thread
#16
Instructor
Thread Starter
It's actually a .1 PCM center stack that the previous owner had refinished in black. Looks great in my opinion.
#17
Racer
trying to decide if i should tackle it myself or send it off to a place like bumperplugs. it looks like a real PITA job.
#18
Instructor
Thread Starter
yeah i was going to ask if you did that or it came that way. that is the next mod up on my list, i don't like the volcano gray center stack. it looks so out of place IMO.
trying to decide if i should tackle it myself or send it off to a place like bumperplugs. it looks like a real PITA job.
trying to decide if i should tackle it myself or send it off to a place like bumperplugs. it looks like a real PITA job.
I've removed the PCM before which wasn't hard just time consuming as I was taking it slow so as not to scratch anything. I've then watched a few vids on youtube on how to disassemble both the PCM and climate control bar to replace various buttons and controls. Again, not hard but time consuming. The painting itself should be simple and the key to success is in the surface prep work.
I'd love to see the result if you do choose to DIY the color change.
Last edited by SWO Daddy; 03-21-2022 at 12:37 PM.
The following users liked this post:
SWO Daddy (03-21-2022)
#20
Instructor
Thread Starter
#21
Instructor
Thread Starter
Quick functional mod. The black and gray key fob seems flimsy so these inexpensive covers provide both protection and a little bling. Yes, I know I could have removed the fob components and installed in the .2 fob, but chose this route.
The following 4 users liked this post by SWO Daddy:
The following users liked this post:
SWO Daddy (10-19-2023)
#28
Instructor
Thread Starter