Mark this thread as Unsold
951 / 944 scraps
#1
Burning Brakes
Thread Starter
Join Date: Aug 2006
Location: Fredericksburg VA
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
951 / 944 scraps
Category: Steering & Suspension
Price (no $ sign please): $300
Private or Vendor Listing: Private Listing
Part fits (select ONLY those which apply): 924/931/944/951/968
Location (Region): NorthEast
Item Condition: Used
/begin tongue in cheek comments
"Original and rare 944/951 parts! All have been either raced or driven by teens!! In any case they came off old wrecked diamonds in the rough. Obviously this stuff is pure gold and I will not sell for less... I know what I got!!"
/end tongue in cheek comments
Seriously I have owned about 9 of these cars and now have 6 vertebrae fused so being 6'5" I can't work on them let alone get into one to drive it.
Since I can no longer work on cars so this stuff has to go or it will go to the recycler for aluminum / steel scrap value.
Probably will hold it for about a week or two and then it's gone for weight so to say I am negotiable is an understatement.
What I have pictures for right now are;
944 early model front lower control arms and struts (rebuild-able kind with removable nuts for a cartridge) springs have 3 blue dots on them.
951 struts not too sure of the year but I thought they were 1988.
Bumpers (was going to smooth them off and powder coat but I can't).
Clutch housing.
Overflow tank.
951 radiator that has some bends and I don't know if it still holds pressure.
AC condenser same story but from an early model I think.
Early manual steering rack
The 951 struts are negotiable.
The rack is listed for $300. But you can load up anything else above that is still here. Please take as much as you can carry!
What I don't currently have pictures but will post some when I un- bury them in the garage and will individually price when I post a picture.
Turbo from 88 (I think but will post numbers when I pull it out)
DMEs from various years.
Turbo gauge for pillar pod
Pillar pod
Early 83 944 engine with bent valves and a broken screw in the water neck area.
sun visors, bumper corners (plastic), various other stuff I don't remember.
Door seal kit
new set of early strut cartridges
Pair of decent early cookies.
More as I get able to clear the garage.
Also I am looking for a patent attorney so if you know about Axial Flux machines then I can do a trade. ;-)
Thanks and I hope I haven't violated any rules this time
JC
#2
Hi- Do you happen to have airbox brackets for '83 944? One attaches to the radiator & other is below coolant reservoir. I have a stock airbox, but PO hacked up brackets when they installed aftermarket airfilter...
Also could use a grommet for where the snorkel goes into the fender well.
Thanks!
Dave
Also could use a grommet for where the snorkel goes into the fender well.
Thanks!
Dave