Rennlist - Porsche Discussion Forums

Notices
 
Page 1 of 20
1
2
3
4
5
6
11
Last »
Search: Posts Made By: Gus
Showing results 1 to 25 of 497
Search took 1.03 seconds.
Forum: 964 Forum
Yesterday, 09:42 PM
Replies: 92
Views: 39,680
Posted By Gus

What is the thickness of the aluminum sheeting...

What is the thickness of the aluminum sheeting that you used. Very good job, looks really trick-
Forum: 964 Forum
03-18-2024, 02:10 PM
Replies: 92
Views: 39,680
Posted By Gus

@CosMoon- I agree with you 2 vent hoses are over...

@CosMoon- I agree with you 2 vent hoses are over kill. I block the prebutterfly off as well as adding the one way valve to the main crank vent and have not had any oil issues with blow back into the...
Forum: 964 Forum
02-19-2024, 11:46 AM
Replies: 4
Views: 513
Posted By Gus

More thoughts - check to see if motors can turn...

More thoughts - check to see if motors can turn cable when not hooked to transmission. Then check to see if cables will turn trans when not hooked to motors Use an electric drill to check - put...
Forum: 964 Forum
02-18-2024, 02:56 PM
Replies: 4
Views: 513
Posted By Gus

Have you checked transmission housing. I found...

Have you checked transmission housing. I found that both transmission case bolts had backed out allowing for gear play.
Forum: 964 Forum
01-19-2024, 12:35 PM
Replies: 52
Views: 11,213
Posted By Gus

Fuel lines

I went an opposite route and made my fuel lines using aircraft AN fittings and metric conversion fittings with stainless steel fuel lines. The fits and fuel lines were very easy to make with just a...
Forum: 964 Forum
12-18-2023, 12:29 PM
Replies: 36
Views: 3,094
Posted By Gus

Caliper/disc size

One restrictive factor to the size of caliper you can install is the size of disc that your wheel will allow. There are adapters available which allow you to up size the caliper and disk. Most are...
Forum: 964 Forum
11-24-2023, 09:29 PM
Replies: 29
Views: 4,175
Posted By Gus

Pink to Red

I came up with a solution to the pink (faded pink) tail lights years ago. The use of a transparent rich red vinyl film to cover the tail lights and center sections. I have sold and ship the vinyl...
Forum: The Rennlist Marketplace
09-15-2023, 07:11 PM
Replies: 3
Views: 1,831
Posted By Gus

Yes - still available- have 2 interested but not...

Yes - still available- have 2 interested but not a firm buy yet
Forum: The Rennlist Marketplace
09-12-2023, 09:21 AM
Replies: 3
Views: 1,831
Posted By Gus

Yes, still available.

Yes, still available.
Forum: The Rennlist Marketplace
09-11-2023, 12:55 PM
Replies: 3
Views: 1,831
Posted By Gus

OZ Racing Wheels

For Sale:  4 OZ Raciing wheels - 2-  8 X 18 ET50 /  2 - 10 x 18 ET65.  Style wheels are ALLEGGERITA.    Color is ANTHRACITE ( Gun Metal ). Wheels are in good shape.  Have run these on my 964 C2 with...
Forum: 964 Forum
08-30-2023, 08:58 AM
Replies: 3
Views: 753
Posted By Gus

Wheels

I have some OZ 18’s that I used as track wheels - just posted listing several days ago
have - 2 - 8 inch. 3 - 9 inch, 2 - 10 inch and 2 - 12 inch.
I ran the 8, 9, and 10’s with spacers. I did roll...
Forum: 964 Forum
08-27-2023, 02:18 PM
Replies: 0
Views: 553
Posted By Gus

OZ 18 Inch Alleggerita Wheels for Sale

I have several OZ Alleggerita wheels for sale that are taking up space -
I have run all of these wheels on my 964. The 8 and 9 inch widths were run with spacers and no body modifications. The 8 x...
Forum: 964 Forum
08-10-2023, 12:00 PM
Replies: 31
Views: 16,521
Posted By Gus

Pic of bolt holes passenger side Note inside hole is not used for WB

https://cimg0.ibsrv.net/gimg/rennlist.com-vbulletin/2000x1504/image_55d0fbdac3559c1c2a1fd878deef8148202360b8.jpg
Forum: 964 Forum
08-10-2023, 08:45 AM
Replies: 31
Views: 16,521
Posted By Gus

It’s really very straight forward. Open the...

It’s really very straight forward. Open the frunk and look at the back left and right side of the spare tire area. You will see three bolt holes on the left and right side on the floor area. The 2...
Forum: 964 Forum
07-01-2023, 05:02 PM
Replies: 81
Views: 13,595
Posted By Gus

Inyerestef

Yes, I am still interested in alum center section.
gus
Forum: 964 Forum
06-12-2023, 11:10 AM
Replies: 7
Views: 1,147
Posted By Gus

Don - yes, info I was looking for / thanks. I...

Don - yes, info I was looking for / thanks. I have an electric PS pump so lines are different- but hook up is the same. Thanks for the help/ info
Forum: 964 Forum
06-10-2023, 04:28 PM
Replies: 7
Views: 1,147
Posted By Gus

Great info - just what I was looking for diagrams...

Great info - just what I was looking for diagrams and notes really help. Thank you so much gentlemen 👍👍
Forum: 964 Forum
06-10-2023, 08:42 AM
Replies: 7
Views: 1,147
Posted By Gus

Thanks - but that is the fitting on the power...

Thanks - but that is the fitting on the power steering pump. I need to know the fittings on the upper part of the steering rack. I may be shown in the lower part of the diagram that you posted but...
Forum: 964 Forum
06-06-2023, 05:15 PM
Replies: 20
Views: 2,635
Posted By Gus

Ok / here are pictures of support rods I built...

Ok / here are pictures of support rods I built for speedster bubble cover. The longer rods have some length adjustment in the middle. The short back rods are adjust for length at the rod ends. ...
Forum: 964 Forum
06-06-2023, 04:49 PM
Replies: 20
Views: 2,635
Posted By Gus

I had to design a system to fit to the speedster...

I had to design a system to fit to the speedster cover. It still needs a little work as I used rod ends on 2 of the lift rods. this allows too much movement in the cover. I used 4 rods (legs) 2...
Forum: 964 Forum
06-06-2023, 04:30 PM
Replies: 10
Views: 2,250
Posted By Gus

Ditto - PM me also OR based on number of folks...

Ditto - PM me also OR based on number of folks interested and age of our cars there is significant need for this knowledge. Maybe some one could be kind enough to pub instructions here.
Forum: 964 Forum
06-06-2023, 09:42 AM
Replies: 20
Views: 2,635
Posted By Gus

The cut out behind the front wheels is to allow...

The cut out behind the front wheels is to allow the escape of air from the front fender well. This reduces a possibility of lift. This was an early idea and serves the same purpose as the vents on...
Forum: 964 Forum
06-05-2023, 11:53 AM
Replies: 37
Views: 5,717
Posted By Gus

Revolve40 Like your seats - look good, the...

Revolve40
Like your seats - look good, the transitional colored pads works well.
Forum: 993 Forum
06-04-2023, 07:06 PM
Replies: 54
Views: 47,732
Posted By Gus

IxLR8 - read your comments “The metal line is...

IxLR8 - read your comments
“The metal line is the pressure line from the power steering pump and the rubber hose which then turns into a plastic line, is the return line“
I had the upper seal on...
Forum: 964 Forum
06-04-2023, 04:43 PM
Replies: 37
Views: 5,717
Posted By Gus

Have Recaro custom pole positions ...

Have Recaro custom pole positions
https://cimg4.ibsrv.net/gimg/rennlist.com-vbulletin/1500x2000/img_0757_62c4163746255e7b42c400862ef0f2004e89fca1.jpeg
Showing results 1 to 25 of 497
 
Page 1 of 20
1
2
3
4
5
6
11
Last »


 
Forum Jump


All times are GMT -3. The time now is 01:14 PM.