Rennlist - Porsche Discussion Forums

Notices
 
Page 1 of 20
1
2
3
4
5
6
11
Last »
Search: Posts Made By: haygeebaby
Showing results 1 to 25 of 498
Search took 0.47 seconds.
Forum: 993 Forum
04-01-2024, 12:19 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

Nice work - thanks for sharing your journey with...

Nice work - thanks for sharing your journey with us.
For the plug to the TPS - I can plug mine on and off without much trouble.
It just has to go on an angle.

What boost numbers are you getting...
Forum: 993 Forum
03-26-2024, 06:29 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

Sorry Cosmo - I'm probably throwing too much...

Sorry Cosmo - I'm probably throwing too much information at you all at once.
I think its best to get the basic kit setup and then enjoy it for a while.
The basic kit does work well. SC whine will...
Forum: 993 Forum
03-25-2024, 09:04 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

Nice well done. Check that AFR when you...

Nice well done.
Check that AFR when you accelerate.
Make sure you are getting enough fuel.
You don't want to grenade your engine.
I'm getting high 11's / low 12's for AFR
Around 14/15 when...
Forum: 993 Forum
03-21-2024, 06:38 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

This is my configuration. But using carbon fiber...

This is my configuration. But using carbon fiber intake pipe to keep the intake air cooler as metal will just keep absorbing heat.
Now is the time to weld in some bungs for sensors if you are...
Forum: 993 Forum
03-21-2024, 06:06 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

Ok - I can see what's happened. They have pushed...

Ok - I can see what's happened. They have pushed the charge-cooler further back into the engine cavity. Thus leaving very little room. So now the ISV needs to be located near the throttle body.
And...
Forum: 993 Forum
03-17-2024, 01:21 PM
Replies: 68
Views: 3,993
Posted By haygeebaby

Cosmo - just some thoughts from my experience...

Cosmo - just some thoughts from my experience with the TPC kit.

- my kit doesn't need to have the ISV round mount cut from the intake elbow. If you source a longer intake pipe to move the elbow...
Forum: 993 Forum
03-15-2024, 12:21 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

A good way to get the throttle cable configured...

A good way to get the throttle cable configured correctly is to take your cell phone and film the throttle body butterfly while you step on accelerator in the drivers seat.
Then adjust and repeat...
Forum: 993 Forum
03-14-2024, 03:27 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

Ok - this is my setup for the pipes and hoses. ...

Ok - this is my setup for the pipes and hoses.
My car is a 1994 model. I have a non varioram engine. I am using the Eaton Gen IV SC setup from TPC.

Single barb from the TPC intake manifold -...
Forum: 993 Forum
03-13-2024, 07:16 AM
Replies: 68
Views: 3,993
Posted By haygeebaby

Cut the cruise control tab off. No other way. ...

Cut the cruise control tab off.
No other way.
Also - if you are using the stock engine lid / spoiler - you will need to cut some sheet metal from that as well.
And most probably drop the engine a...
Forum: 993 Forum
03-06-2024, 04:48 AM
Replies: 3
Views: 575
Posted By haygeebaby

Congrats - 1 993 for daily and 1 993 to race? ...

Congrats - 1 993 for daily and 1 993 to race?
Its good to be the king !
Forum: 993 Forum
02-29-2024, 01:58 AM
Replies: 8
Views: 934
Posted By haygeebaby

I did this DIY a few moons ago. Not difficult if...

I did this DIY a few moons ago. Not difficult if you have the tools and some time.
At the same time I would do all your bushes as well - control arms etc.
Brake discs, suspension and top mounts,...
Forum: 993 Forum
01-12-2024, 05:22 AM
Replies: 92
Views: 7,430
Posted By haygeebaby

Welcome back bro.

Welcome back bro.
Forum: 993 Forum
01-05-2024, 11:50 PM
Replies: 14
Views: 2,059
Posted By haygeebaby

Hi Sondre Happy new year. Hope all is well. I...

Hi Sondre
Happy new year. Hope all is well.
I spend hours trying to get the plate off. It's pressed on and seized.
I ended up finding a pro who rebuilds these things and had them replace the hall...
Forum: 993 Forum
12-29-2023, 01:24 PM
Replies: 1
Views: 597
Posted By haygeebaby

To end this thread - both methods work fine. I...

To end this thread - both methods work fine.
I continued with the ground cable connected to the transmission mount.
Forum: 993 Forum
12-29-2023, 01:15 PM
Replies: 24
Views: 2,162
Posted By haygeebaby

Ok - jobs finally done and everything is back...

Ok - jobs finally done and everything is back together.
Here are the final thoughts on the process and starter motor:

WOSP unit is heavier than stock Bosch starter by .5kg (Bosch = 4.5kg / WOSP...
Forum: 993 Forum
12-19-2023, 06:54 AM
Replies: 1
Views: 597
Posted By haygeebaby

Ground cable from starter or transmission mount?

Guys
I didn't take a picture of this before I started undoing things.
So I'm kicking myself and have to ask you guys how the ground cable should be connected up.

When I removed the cables from...
Forum: 993 Forum
12-18-2023, 09:40 PM
Replies: 3
Views: 471
Posted By haygeebaby

Thank you Mr Holger - much appreciated. ...

Thank you Mr Holger - much appreciated.
Longitudinal carrier it is - but this thing has a few names.
PET calls it "bracket".
Workshop manual calls it "side member" (I can see this as the tq...
Forum: 993 Forum
12-18-2023, 07:12 AM
Replies: 24
Views: 2,162
Posted By haygeebaby

No idea K7. Maybe metal fatigue over time?...

No idea K7.
Maybe metal fatigue over time? Maybe imperfections in the metal that lead up to this after years of use.
Reminds me of my AC bracket - one day a corner piece just broke off.
I'd be...
Forum: 993 Forum
12-18-2023, 07:08 AM
Replies: 3
Views: 471
Posted By haygeebaby

Toque Specs for trans man/tip

Hi guys
Having difficulty finding the toque specs for the following.
Can anyone help?

15 - big bush support bracket to tip transmission - 4 bolts - 34 ft-lb
9/10 - large bolt for big bush - 63...
Forum: 993 Forum
12-15-2023, 11:13 PM
Replies: 68
Views: 3,993
Posted By haygeebaby

Cosmos - question - why not lose the complex...

Cosmos - question - why not lose the complex Unichip device and 7+8 injector and go a custom ECU from Protomotive and upgrade fuel injectors?
In my experience this vastly simplified things and no...
Forum: 993 Forum
12-14-2023, 05:03 AM
Replies: 8
Views: 1,253
Posted By haygeebaby

Hehehehe - lets hope he fixed it already.

Hehehehe - lets hope he fixed it already.
Forum: 993 Forum
12-12-2023, 10:29 PM
Replies: 24
Views: 2,162
Posted By haygeebaby

Question - anyone know how to wire up the WOSP...

Question - anyone know how to wire up the WOSP unit?
I am assuming exactly the same as the stock unit.
But need to change the connector on the signal wire.
Forum: 993 Forum
12-12-2023, 10:27 PM
Replies: 24
Views: 2,162
Posted By haygeebaby

Update: engine and trans came out. Separated...

Update: engine and trans came out.
Separated the two and sure enough the broken off piece was in there.

...
Forum: 993 Forum
12-12-2023, 10:18 PM
Replies: 8
Views: 1,253
Posted By haygeebaby

Rattle gun should get it off easy.

Rattle gun should get it off easy.
Forum: 993 Forum
12-08-2023, 06:18 AM
Replies: 24
Views: 2,162
Posted By haygeebaby

Interesting times - looks like a few people...

Interesting times - looks like a few people having starter motor problems and engine drops happening at the same time as me.
Engine will probably come out tomorrow - have been doing a little bit...
Showing results 1 to 25 of 498
 
Page 1 of 20
1
2
3
4
5
6
11
Last »


 
Forum Jump


All times are GMT -3. The time now is 05:50 PM.