Rennlist - Porsche Discussion Forums

Notices
 
Page 1 of 20
1
2
3
4
5
6
11
Last »
Search: Posts Made By: CabrioArtie
Showing results 1 to 25 of 496
Search took 0.47 seconds.
Forum: 993 Forum
Today, 05:43 PM
Replies: 0
Views: 33
Posted By CabrioArtie

Differences between 964 and 993 Shift Knob

Looking to replace my worn shift knob.

Wondering if there are any differences between 964-424-075-05-4YU and 993-424-075-00-4YU. The 964 knob is $200+ less than the 993 version.

Will the 964...
Forum: 993 Forum
02-26-2024, 02:09 PM
Replies: 10
Views: 617
Posted By CabrioArtie

Did this replacement a number of years ago, so...

Did this replacement a number of years ago, so went back through my orders and I believe the cardboard at the end of the elastic straps is part number 993-561-835-00.

I would say, I'm not...
Forum: 993 Forum
02-20-2023, 02:15 PM
Replies: 7
Views: 929
Posted By CabrioArtie

Yes, you need to remove the Faceplate and then...

Yes, you need to remove the Faceplate and then disassemble it. I have done this on a CDR-220.
Forum: 993 Forum
02-12-2023, 06:23 PM
Replies: 4,331
Views: 676,547
Posted By CabrioArtie

Replaced my cracked center taillight/reflector...

Replaced my cracked center taillight/reflector with a new one. Looks so much better.
...
Forum: 993 Forum
02-03-2023, 02:10 PM
Replies: 43
Views: 3,536
Posted By CabrioArtie

The top will not latch back if the latch motors...

The top will not latch back if the latch motors aren't touching the frame. Push down on the top a small amount while pushing the switch.
Forum: 993 Forum
02-02-2023, 11:21 PM
Replies: 43
Views: 3,536
Posted By CabrioArtie

I would start with pulling the carpet behind the...

I would start with pulling the carpet behind the rear seats back and see if the motor is running while pressing the switch. If it isn't running, test and see if it/s getting power. With these results...
Forum: 993 Forum
08-03-2022, 08:59 PM
Replies: 62
Views: 4,426
Posted By CabrioArtie

2011 Turbo S in PTS Azzurro Blue Met ...

2011 Turbo S in PTS Azzurro Blue Met
https://cimg2.ibsrv.net/gimg/rennlist.com-vbulletin/600x428/997_edited_07f3f81be274e06b60ac9b1f25eaae956dae2c31.jpg

1997 C2 in Arena Red...
Forum: 993 Forum
04-03-2022, 03:49 PM
Replies: 38
Views: 3,714
Posted By CabrioArtie

Purchased a Homelink off of eBay and wired it...

Purchased a Homelink off of eBay and wired it into switched power so it only works when the key is in the ignition. Then I mounted it into the ash tray so it's hidden.
...
Forum: 993 Forum
03-24-2022, 08:28 PM
Replies: 26
Views: 2,247
Posted By CabrioArtie

yes, I use one, works great and adds a layer of...

yes, I use one, works great and adds a layer of protection to the car when washing. Also, does a great job on the wheels.
Forum: 993 Forum
02-01-2022, 01:51 PM
Replies: 10
Views: 4,262
Posted By CabrioArtie

Thanks, I'm not getting any drips on the heat...

Thanks, I'm not getting any drips on the heat exchangers and there is no smell or smoke.

I wasn't planning on doing anything at the moment, but was curious if this was caused by a failing gasket...
Forum: 993 Forum
01-31-2022, 06:54 PM
Replies: 10
Views: 4,262
Posted By CabrioArtie

Oil Leak From Valve Cover Bolts

Looking over the engine today and noticed some wetness from these two bolts. Everything else is dry. Left side upper cover.

Is this a gasket replace or something else?
...
Forum: 993 Forum
01-17-2022, 11:03 PM
Replies: 11
Views: 1,426
Posted By CabrioArtie

Just installed Konis Special Active and ROW M033...

Just installed Konis Special Active and ROW M033 springs in October of last year. I love the lowered look and better handling. And, the firmness is just right.
2. I do not have any float issues.
3....
Forum: 993 Forum
12-31-2021, 10:54 PM
Replies: 4
Views: 728
Posted By CabrioArtie

I just had the same issue a couple of weeks ago....

I just had the same issue a couple of weeks ago. I communicated with Tore, and the only two solutions are either cut the wire off of the connector or put a T-Tap on the wire.
Forum: 997 Turbo Forum
12-31-2021, 08:35 PM
Replies: 36
Views: 5,047
Posted By CabrioArtie

Here's a picture of my 2011 PTS Turbo S in Azurro...

Here's a picture of my 2011 PTS Turbo S in Azurro California Metallic.

https://cimg8.ibsrv.net/gimg/rennlist.com-vbulletin/600x428/997_edited_146209d4c40a165c2d51723d1473646d649f135f.jpg
Forum: 993 Forum
12-19-2021, 02:16 PM
Replies: 8
Views: 816
Posted By CabrioArtie

Part number: 993-504-521-00, costs about $5.00

Part number: 993-504-521-00, costs about $5.00
Forum: 993 Forum
10-09-2021, 01:04 AM
Replies: 13
Views: 840
Posted By CabrioArtie

Just so we've covered all the simple items first,...

Just so we've covered all the simple items first, the cabrio top switch can be pushed both at the top and the bottom of the switch, Depressing the front (forward) part of the switch closes the top...
Forum: 993 Forum
10-08-2021, 07:35 PM
Replies: 13
Views: 840
Posted By CabrioArtie

The light in the clock does not illuminate unless...

The light in the clock does not illuminate unless the top is in the process of opening or closing. When the top is completely open or closed the light will not be illuminated.

What happens when...
Forum: 993 Forum
09-18-2021, 12:30 AM
Replies: 9
Views: 1,000
Posted By CabrioArtie

Started checking all of the suggestions from...

Started checking all of the suggestions from everyone and everything else in the suspension. Did the front this evening and will do the rear this weekend.

In the front I believe the driver’s side...
Forum: 993 Forum
09-13-2021, 02:54 AM
Replies: 9
Views: 1,000
Posted By CabrioArtie

Are you referring to the mount point on the shock...

Are you referring to the mount point on the shock or the drop link between the shock and the sway bar? I was pretty sure everything was correct, but when the suspension is moving, I don't know how...
Forum: 993 Forum
09-13-2021, 02:50 AM
Replies: 9
Views: 1,000
Posted By CabrioArtie

From the short drive around the block, it...

From the short drive around the block, it appeared that the clunking was when I was making turns. Or going over some uneven surfaces. I know the wheel nuts are torqued properly, that’s not the issue....
Forum: 993 Forum
09-12-2021, 11:05 PM
Replies: 9
Views: 1,000
Posted By CabrioArtie

As far as I know all is torqued properly, but I...

As far as I know all is torqued properly, but I will check the that all of the nuts are tight.

I will check the sway bar too.
Forum: 993 Forum
09-12-2021, 08:44 PM
Replies: 9
Views: 1,000
Posted By CabrioArtie

Clunking sound from my new Suspension

Just finished refreshing my suspension, put in Komi Active struts/shocks and M033 springs all around, new strut/shock mounts, new ball joints in the front along with new tie rods. Additionally in the...
Forum: 993 Forum
09-06-2021, 10:45 PM
Replies: 39
Views: 3,149
Posted By CabrioArtie

Just registered, am I eligible?

Just registered, am I eligible?
Forum: 993 Forum
09-03-2021, 01:18 AM
Replies: 6
Views: 971
Posted By CabrioArtie

Opinions, on Rear Toe Control Arm

In doing the rear suspension I have found that the rear toe control arms are bad, any opinions on replacements? Porsche, URO or some other manufacturer?
Forum: 993 Forum
09-01-2021, 11:36 PM
Replies: 2
Views: 497
Posted By CabrioArtie

Rear Koni Install Question

Installing Koni Acitves with M033 springs in the rear and the original Monroes had this part on the lower end of the shock called "Supporting mount" (993 333 110 01), see pictures of the part on the...
Showing results 1 to 25 of 496
 
Page 1 of 20
1
2
3
4
5
6
11
Last »


 
Forum Jump


All times are GMT -3. The time now is 07:27 PM.