Rennlist - Porsche Discussion Forums

Notices
 
Page 1 of 19
1
2
3
4
5
6
11
Last »
Search: Posts Made By: ZEUS+
Showing results 1 to 25 of 469
Search took 0.55 seconds.
Forum: 928 Forum
11-08-2023, 01:00 AM
Replies: 28
Views: 13,347
Posted By ZEUS+

For stubborn rack bellows or cv boots, hot water...

For stubborn rack bellows or cv boots, hot water works well. Put the desired end in boiling water for a minute or two. Wipe off any water, lube and install It will become more pliable and stretch...
Forum: 928 Forum
10-17-2023, 12:43 AM
Replies: 9
Views: 318
Posted By ZEUS+

Fuse 20 is for the headlight washers, fuse 21 is...

Fuse 20 is for the headlight washers, fuse 21 is for the windows and fuse 22 is for the fuel pump. Does the fuse blow when switch is pressed for up, down or both ?
Forum: 928 Forum
10-15-2023, 12:59 AM
Replies: 11
Views: 500
Posted By ZEUS+

No specific tips, just prying and patience. This...

No specific tips, just prying and patience. This might be helpful : https://rennlist.com/forums/928-forum/303903-vacuum-actuator-replacement.html
Forum: 928 Forum
10-14-2023, 01:22 AM
Replies: 15
Views: 646
Posted By ZEUS+

https://cimg9.ibsrv.net/gimg/rennlist.com-vbulleti...

https://cimg9.ibsrv.net/gimg/rennlist.com-vbulletin/600x281/ceb_622e208eb47d65ca45194d79574a000fe471d606.jpg
The CEB wire terminals in diagrams are identified with a letter and 2 digits. The letter...
Forum: 928 Forum
10-13-2023, 03:11 PM
Replies: 6
Views: 382
Posted By ZEUS+

. The dash light potentiometer is on sheet 2, E2....

. The dash light potentiometer is on sheet 2, E2. Check for loose connections, power in and out. Found a thread with info on the...
Forum: 928 Forum
10-12-2023, 09:37 PM
Replies: 4
Views: 333
Posted By ZEUS+

Those diagrams are for the door lock/key...

Those diagrams are for the door lock/key cylinder, not the motor. A 4 pin motor is pre 89. The wiring diagram for an 88 shows pin 3 to be ground. It would be easier with the connector for wire...
Forum: 928 Forum
10-12-2023, 09:06 PM
Replies: 27
Views: 779
Posted By ZEUS+

Locating an open circuit can be a tedious task....

Locating an open circuit can be a tedious task. Unless the open/broken wire is easily visible, it's a search mission. You have to follow the path of power from source to open/break. Wires can break...
Forum: 928 Forum
10-11-2023, 12:25 AM
Replies: 27
Views: 779
Posted By ZEUS+

The bulb control is for rear lights only. Fuses...

The bulb control is for rear lights only. Fuses 28&29 receive power from light switch. Fuse 28 does supply power to bulb control terminal 7 for LR tail/marker and fuse 29 supplies power to terminal 5...
Forum: 928 Forum
09-27-2023, 12:15 AM
Replies: 23
Views: 1,056
Posted By ZEUS+

TDC on exhaust stroke rotor will be 180 out.

TDC on exhaust stroke rotor will be 180 out.
Forum: 928 Forum
09-26-2023, 11:55 PM
Replies: 23
Views: 1,056
Posted By ZEUS+

The rotor should be tight on the shaft. You said...

The rotor should be tight on the shaft. You said it "wasn't fitted snuggly" and you "can only turn it clockwise a tiny bit". Turning it clockwise will retard the spark. The rotor position in the pic...
Forum: 928 Forum
09-19-2023, 04:48 AM
Replies: 10
Views: 520
Posted By ZEUS+

It looks like you have had this problem for a...

It looks like you have had this problem for a while. https://rennlist.com/forums/928-forum/1319576-transmission-leak-from-breather-hole-weep-hole.html If the seals between trans and differential are...
Forum: 928 Forum
09-11-2023, 05:58 AM
Replies: 21
Views: 1,027
Posted By ZEUS+

A test light to the neg coil terminal will flash...

A test light to the neg coil terminal will flash during cranking if there is signal. There would be no secondary ignition kv (plug wire voltage) without signal.
Forum: 928 Forum
09-09-2023, 10:52 PM
Replies: 21
Views: 1,027
Posted By ZEUS+

Have you checked kv on both coil wires ? With all...

Have you checked kv on both coil wires ? With all the testing/cranking and fuel smell from exhaust, plugs could be fouled by now.
Forum: 928 Forum
09-08-2023, 04:02 AM
Replies: 28
Views: 1,221
Posted By ZEUS+

It's not even a good comparison. Two totally...

It's not even a good comparison. Two totally different vehicles. Just like some people talk for the sake of talking, seems like some people write for the sake of writing. I found this article also. I...
Forum: 928 Forum
08-31-2023, 08:05 PM
Replies: 63
Views: 3,489
Posted By ZEUS+

When you jumped pin 1, did you just crank engine...

When you jumped pin 1, did you just crank engine over ? If smoke resulted from starter engagement alone there is high current draw.
Forum: 928 Forum
08-26-2023, 08:56 PM
Replies: 6
Views: 482
Posted By ZEUS+

Possibly the alternator has bad diodes or...

Possibly the alternator has bad diodes or rectifier causing drain. This thread might be helpful. Even though you don't mention any abnormal light activity, the alternator could still be the cause. ...
Forum: 928 Forum
08-26-2023, 08:46 PM
Replies: 8
Views: 387
Posted By ZEUS+

Make sure all connections are clean and tight,...

Make sure all connections are clean and tight, battery, grounds, starter etc. Possibly a failing ignition switch.
Forum: 928 Forum
08-23-2023, 04:09 PM
Replies: 8
Views: 404
Posted By ZEUS+

Happened to me twice in my 84. First time the...

Happened to me twice in my 84. First time the welder just welded the crack. It broke again a few years later. A different welder was more thorough. Repaired the crack and welded in gussets for...
Forum: 928 Forum
07-18-2023, 09:42 PM
Replies: 14
Views: 648
Posted By ZEUS+

If it is the cam hub(s), you don't want to keep...

If it is the cam hub(s), you don't want to keep running it. You said "It certainly seems to be related to exhaust cams." The gear and hub are on the exhaust cam. It was actually easy to diagnose,...
Forum: 928 Forum
07-18-2023, 04:09 PM
Replies: 40
Views: 1,552
Posted By ZEUS+

Mine did the exact same thing. I would pull fuse...

Mine did the exact same thing. I would pull fuse 42(fuel pump,O2 sensor). Engine would then start and I just pushed fuse back in. Only happened when cold. My problem was a failing MAF.
Forum: 928 Forum
07-18-2023, 12:59 PM
Replies: 14
Views: 648
Posted By ZEUS+

I had a similar noise. It was the left/drivers...

I had a similar noise. It was the left/drivers side cam hub. https://rennlist.com/forums/928-forum/530569-deceptive-engine-knock.html
Forum: 928 Forum
07-17-2023, 08:17 PM
Replies: 11
Views: 597
Posted By ZEUS+

Connect one lead of an ohm meter to one wire....

Connect one lead of an ohm meter to one wire. With the other lead, touch each wire until you have a resistance value. Now you have paired the motor leads. You can supply power and ground to the wires...
Forum: 928 Forum
07-16-2023, 01:04 AM
Replies: 49
Views: 3,423
Posted By ZEUS+

If you still have the old oil filter you might...

If you still have the old oil filter you might want to cut it open and have a look. You bought it as a non runner and it sat for 25 years. So the flex plate migration has loaded the crank for a long...
Forum: 928 Forum
07-07-2023, 08:59 PM
Replies: 42
Views: 2,307
Posted By ZEUS+

The basic no start diagnosis is to determine if...

The basic no start diagnosis is to determine if there is fuel and spark, unless it is a no crank condition or a mechanical failure. The easiest test is to remove the large vacuum hose from the intake...
Forum: 928 Forum
07-07-2023, 06:14 PM
Replies: 5
Views: 562
Posted By ZEUS+

This is a definite indication of atf cooler...

This is a definite indication of atf cooler failure. I have seen this numerous times in various makes and models. Do not start vehicle, run engine or drive. The ethylene glycol in coolant destroys...
Showing results 1 to 25 of 469
 
Page 1 of 19
1
2
3
4
5
6
11
Last »


 
Forum Jump


All times are GMT -3. The time now is 04:59 AM.