Rennlist - Porsche Discussion Forums

Notices
 
Page 1 of 20
1
2
3
4
5
6
11
Last »
Search: Posts Made By: McCulla
Showing results 1 to 25 of 494
Search took 0.64 seconds.
Forum: 997 Forum
07-25-2019, 01:07 PM
Replies: 18
Views: 2,792
Posted By McCulla

OK, I'm the dumbass. I see in the Craigslist ad...

OK, I'm the dumbass. I see in the Craigslist ad that the IMS is not done. Sorry for not reading!
Forum: 997 Forum
07-25-2019, 12:58 PM
Replies: 18
Views: 2,792
Posted By McCulla

Sorry to be repeating myself (I just private...

Sorry to be repeating myself (I just private messaged you with this question..) but does this mean that the bearing has not been changed?

Thank you.
Forum: 997 Forum
08-16-2017, 02:23 PM
Replies: 22
Views: 2,583
Posted By McCulla

*starter cable Oh, I forgot -water pump ...

*starter cable

Oh, I forgot -water pump
-driver's side door handle breakage
-(all the dash swtiches losing their surface)

All my service was done at a...
Forum: 997 Forum
08-16-2017, 02:18 PM
Replies: 22
Views: 2,583
Posted By McCulla

AWDGuy, you are my evil twin.. Alternator...

AWDGuy, you are my evil twin..

Alternator (x2)
PCM
Battery/Y/started cable
Air/oil separator
CEL diagnosis lead to:
Coil packs
Change all lifters ($$$)
Cam position sensor
Forum: 997 Forum
08-16-2017, 01:14 PM
Replies: 22
Views: 2,583
Posted By McCulla

As they say, opinions are like arse-holes...and I...

As they say, opinions are like arse-holes...and I have one of both.

I have had 5 911's but I didn't daily drive one until I got a 997. 2005 C2 base. I got it at about 25K miles. (if you are...
Forum: Vehicle Marketplace - Old
08-02-2017, 01:05 PM
Replies: 45
Views: 17,713
Posted By McCulla

Absolutely amazing car! I know less than...

Absolutely amazing car!

I know less than nothing about what it takes to build something like this, but the cost of installation of the interior ($27500) caught my eye! Wow!
(Maybe I misread it,...
Forum: 991 GT3, GT3RS, GT2RS and 911R
04-06-2017, 12:57 PM
Replies: 54
Views: 12,307
Posted By McCulla

The minute I saw the pictures of the CTR3 in...

The minute I saw the pictures of the CTR3 in BBI's shop, I instantly thought,
"...Don't do the Bob Hindson Racing shop test drive!!..."
Forum: Vehicle Marketplace - Old
01-24-2017, 01:53 PM
Replies: 19
Views: 9,254
Posted By McCulla

This comment is in no way meant to be a knock on...

This comment is in no way meant to be a knock on this car...but, my first Porsche was a Weissach, also the metallic black, and this repaint kind of hurts my heart...dang!
Forum: Vehicle Marketplace - Old
01-24-2017, 12:46 PM
Replies: 19
Views: 9,254
Posted By McCulla

..what cbracerx said...

..what cbracerx said...
Forum: Vehicle Marketplace - Old
06-10-2016, 01:06 PM
Replies: 18
Views: 5,998
Posted By McCulla

DOH, never mind. I just read his link to the...

DOH, never mind. I just read his link to the "repaired to look like..." story.
Disregard.
Forum: Vehicle Marketplace - Old
06-10-2016, 01:04 PM
Replies: 18
Views: 5,998
Posted By McCulla

(let me first apologize for this post being...

(let me first apologize for this post being completely off topic..)
I'm confused. I was under the impression that the 964 body was introduced in 1989 as a late year release. I'm really going to have...
Forum: 997 Forum
05-13-2015, 01:10 PM
Replies: 44
Views: 12,207
Posted By McCulla

JoeCjr, I'm not sure why you would have any of...

JoeCjr, I'm not sure why you would have any of the black, rubbery sealant sloughing and showing up at this time..I had the valve covers taken off my car to have the lifters replaced and that's the...
Forum: 997 Forum
05-11-2015, 12:52 PM
Replies: 44
Views: 12,207
Posted By McCulla

Cvtbenhogan is right. I did not suffer an IMS...

Cvtbenhogan is right. I did not suffer an IMS failure. The material in my filter was indeed the sealant that other posters thought it was. When I changed my IMS (I elected to do it preventively at a...
Forum: 997 Forum
04-13-2015, 09:41 PM
Replies: 23
Views: 1,463
Posted By McCulla

I did the switches DIY, but it was a pretty tough...

I did the switches DIY, but it was a pretty tough job because the access was really tight. Upside down in the footwell, and very little room for tools. It's a 5 minute job that took me well over an...
Forum: 997 Forum
04-13-2015, 05:19 PM
Replies: 23
Views: 1,463
Posted By McCulla

Petza hit on another symptom that happened with...

Petza hit on another symptom that happened with my car, the cruise would kick off without warning while it was engaged.
Forum: 997 Forum
04-13-2015, 01:05 PM
Replies: 23
Views: 1,463
Posted By McCulla

Wow! I had forgotten about this issue until I...

Wow! I had forgotten about this issue until I read this thread. I had this happen to my '05 non S car. The brake/clutch switch replacement cured it. (I did all of them at the same time).
I recall...
Forum: 997 Forum
04-13-2015, 12:57 PM
Replies: 8
Views: 814
Posted By McCulla

Shardul, did you happen to see what the gray...

Shardul, did you happen to see what the gray Turbo went for? I looked at 3 different Mecum summaries and couldn't see it.
Forum: 997 Forum
04-09-2015, 12:59 PM
Replies: 27
Views: 4,218
Posted By McCulla

The Porsche mats look great but the Weathertech...

The Porsche mats look great but the Weathertech have a dramatically better catch and protect design. If all you want is to keep your shoe heel off the carpet, the Porsche looks cool, but they sure...
Forum: 997 Forum
03-25-2015, 01:00 PM
Replies: 23
Views: 2,256
Posted By McCulla

I'm reading this sort of (sorry) sarcastically...

I'm reading this sort of (sorry) sarcastically feeling like you may have hit the shifter cable break lotto (if that is what actually happened). Losing reverse is the best possible way for this to...
Forum: 997 Forum
03-04-2015, 07:26 AM
Replies: 67
Views: 14,541
Posted By McCulla

Maybe in the context of this thread this question...

Maybe in the context of this thread this question is already answered...but
IIRC the PWIWS updates are really pricey, your indy may not be equipped with this(?) Did you mention if you indy has this...
Forum: 997 Forum
10-20-2014, 01:05 PM
Replies: 41
Views: 16,558
Posted By McCulla

In my 25 yr history with Porsche ownership, I...

In my 25 yr history with Porsche ownership, I went through financial cycles where at certain times I couldn't afford the 911 side. First Porsche was a
911 SC, then $$ decrease made a 944 S2 next,...
Forum: 997 Forum
10-05-2014, 01:07 PM
Replies: 22
Views: 2,435
Posted By McCulla

Here is my (sort of invasive) solution. First, I...

Here is my (sort of invasive) solution. First, I went to a metal fab shop to have some low approach ramps custom built. They are about 5 feet long and raise the car 12". Over engineered they weigh 40...
Forum: 997 Forum
09-29-2014, 10:19 PM
Replies: 11
Views: 1,194
Posted By McCulla

By the way, back to the OP's questions...these...

By the way, back to the OP's questions...these little f*#kers will flat RUIN your paint. Acid internals (I read a Univ of Florida publication about a week ago saying it's the egg masses that have the...
Forum: 997 Forum
09-29-2014, 08:38 PM
Replies: 11
Views: 1,194
Posted By McCulla

NO! Bad idea to put your car in front of a...

NO! Bad idea to put your car in front of a sprinkler! I've had the misfortune of experiencing 2 big time paint etch/hard water deposit incidents from sprinklers! Had to have my new Boxster wet sanded...
Forum: 997 Forum
09-29-2014, 12:13 AM
Replies: 11
Views: 1,194
Posted By McCulla

Hands down the best solution is this...used dryer...

Hands down the best solution is this...used dryer sheets. Take half a dozen out of your laundry room trash when you wash the car. Put them in your wash bucket and after you've sprayed the car down to...
Showing results 1 to 25 of 494
 
Page 1 of 20
1
2
3
4
5
6
11
Last »


 
Forum Jump


All times are GMT -3. The time now is 09:47 AM.